what is beatseqr?

Loading...

Solving problems: LRF support

admin | May 31, 2011 in prototypes | Comments (0)

Tags:

20110531-054204.jpg

When I have a bit more time, I’ll post a video, but I just couldn’t locate mechanically fastening LRF’s to the specs I need. So I drew up a concept on some paper, redrew it in illustrator, exported it to dxf, imported it to sheetcam, and cut a casting mold. I used the smooth-on shore hardness 40 silicone since I’ve decided it’s too tough to work with for my buttons… Turned out pretty good! Maybe a little too tall. But it will be easy enough to slice off this mold and try again. I’m loving the time from concept to iteration. Very fast!! And I’m not committed to hundreds of failed designs. Just a couple few. I’ll even use these for experimental projects.

Comments

Leave a Reply